3.3
User interface - Control panel
Overview
The control panel is used for the control and monitoring of individual drives. You traverse drives
from the control panel by specifying values (e.g. speed setpoint).
Layout of the control panel
The following figure shows as example the various components of the control panel:
①
Activate/deactivate master control
②
Switch-on/switch-off infeed
③
Set/reset drive enable signals
④
Select operating mode
⑤
Control drive (elements vary slightly depending on the set operating mode.)
⑥
Display of the actual values
⑦
Indication of the drive status
Figure 3-9
Example: CU320-2 PN
Restrictions
• The "Switch-on/switch-off infeed"
without a PM240-2 Power Module.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
②
option is only available when using a CU320-2 PN
Startdrive engineering tool
3.3 User interface - Control panel
51