Configuring Digital Inputs - Siemens SINAMICS S120 Commissioning Manual

5. Click in the parameter number field, enter "0" and then confirm with Return.
The complete parameter entry is deleted from the exception list.
The changes in the exception list take effect immediately in online mode.
6. Repeat the process for all other parameters to be removed from the exception list.
7. To save the changes in the exception list retentively, click .
If you remove the parameters from the exception list in offline mode, load the project data
into your drive subsequently. The changes in the exception list take effect immediately when
you switch to online mode.
The modified exception list is taken into account after activation of know-how protection in
online mode. All of the parameters that were removed from the list are then know-how
protected again.
Parameters (see SINAMICS S120/S150 List Manual)
• p7763
• p7764[0...n]
5.7.1.14

Configuring digital inputs

Overview
Digital inputs are used for the acquisition of digital signals. For example, drive enable signals can
be controlled externally. The interconnection of digital inputs is made via BICO interconnections.
For every digital input signal there is the corresponding inverted signal which can also be used
for interconnection.
Simulation mode
The selection box for the terminal evaluation / simulation switchover is only visible online.
CU310-2 PN
You can change the interconnection of the digital inputs on the CU310-2 PN Control Unit in the
"Isolated digital inputs" screen form.
Procedure
Interconnect the signal sources of digital inputs 0 to 3 and 16 to 22 (r0722 and r0723). Several
interconnections are possible.
CU320-2 PN
You can change the interconnection of the digital inputs on the CU320-2 PN Control Unit in the
"Isolated digital inputs" screen form.
Procedure
Interconnect the signal sources of digital inputs 0 to 7, 16, 17, 20 and 21 (r0722 and r0723).
Several interconnections are possible.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Know-how protection OEM exception list, number of indices for p7764
Know-how protection OEM exception list
5.7 Basic parameterization of the drive objects
Commissioning
199