Basic Line Module Booksize - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
6.1 Diagnostics using LEDs
State
Ready DC link
Green / red –
flashing light
2 Hz
Green / –
orange
or
Red / orange
6.1.2.3

Basic Line Module booksize

Table 6-9 Meaning of the LEDs on the Basic Line Module
State
Ready DC link
Off Off
Green Off
Orange
Red
Orange Orange
Red –
Green / red –
flashing light
0.5 Hz
Green / red –
flashing light
2 Hz
Green / –
orange
or
Red / orange
flashing light
290
Description, cause
Firmware download is complete. Wait for POWER ON.
Component detection via LED is activated (p0124).
Note:
Both options depend on the LED status when module recogni‐
tion is activated via p0124 = 1.
Description, cause
Electronic power supply is missing or outside permissible toler‐
ance range.
The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Firmware is being downloaded.
Firmware download is complete. Wait for POWER ON.
Component detection via LED is activated (p0124).
Note:
Both options depend on the LED status when module recogni‐
tion is activated via p0124 = 1.
Remedy
Carry out a POWER ON
–
Remedy
–
–
–
Check the line voltage.
–
Remedy and acknowledge
fault.
–
Carry out a POWER ON
–
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2