Creating A Password For The Users "Sinamics" And "Administrator; Deleting The Password For The User "Sinamics - Siemens SINAMICS S120 Commissioning Manual

5.7.1.5

Creating a password for the users "SINAMICS" and "Administrator"

Overview
You can use this function for the users "SINAMICS" and "Administrator" in online or offline
mode. The procedure is the same for both users.
Requirements
• There is an online connection between the Startdrive project and the drive unit.
This requirement only applies if you create a password in online mode.
Procedure
To create a password for the user "SINAMICS" or "Administrator", proceed as follows:
1. Click on "Specify password".
The "Specify password" dialog opens.
2. Enter the new password in the "New password" input field. Pay attention to upper and lower
case.
3. Repeat the password in the "Confirm password" field.
For security reasons, the password entries displayed in the input fields are encrypted.
4. Click "OK" to confirm the input in the password dialog.
The input dialog is closed if both password entries match. If both entries do not match, the
input dialog box remains open and an error message is displayed. At the same time, the two
entries in the input dialog are cleared. In this case, you must re-enter the password into the
input fields.
5. Save the project to accept the settings.
5.7.1.6

Deleting the password for the user "SINAMICS"

Overview
You can only use this function for the user "SINAMICS" and only in online mode.
Requirements
• There is an online connection between the Startdrive project and the drive unit.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
5.7 Basic parameterization of the drive objects
Commissioning
185