Smc30 Sensor Module Cabinet - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
6.1 Diagnostics using LEDs
6.1.3.3

SMC30 Sensor Module Cabinet

Table 6-27 Meaning of LEDs on the Sensor Module Cabinet SMC30
LED Color
RDY –
READY
Green
Orange
Red
Green/red
Green/red
Green/
orange
or
Red/
orange
OUT > 5 V –
Orange
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: SINAMICS S120/S150 List Manual
300
Status Description, cause
Off The electronics power supply is missing or outside the permis‐
sible tolerance range.
Continu‐ The component is ready for operation. Cyclic DRIVE-CLiQ com‐
ous light munication is taking place.
Continu‐ DRIVE-CLiQ communication is being established.
ous light
Continu‐ This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Flashing Firmware is being downloaded.
light 0.5
Hz
Flashing Firmware download is complete. The system waits for POWER
light 2 Hz ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component rec‐
ognition is activated.
Off The electronics power supply is missing or outside permissible
tolerance range.
Power supply ≤ 5 V.
Continu‐ The electronics power supply for the encoder system is avail‐
ous light able.
Power supply > 5 V
.
1)
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Remedy
–
–
–
Correct fault and ac‐
knowledge
–
Carry out a POWER ON
–
–
–