Siemens SINAMICS S120 Commissioning Manual page 157

Checking the firmware consistency
To check the firmware consistency between your Startdrive project and drive, proceed as follows:
1. Check the firmware version on your memory card using the "General" diagnostics screen
form.
– Connect your PG/PC to a drive device using a LAN cable, and switch on the drive device.
– In your Startdrive project, open the "Online access" entry in the project tree.
– Select the network interface of your PG/PC.
– Double-click "Update accessible devices".
– In the project tree call the "Online & diagnostics" function for the displayed device.
2. Check the firmware version in the catalog information of the Control Unit in your current
Startdrive project.
– To do this, call the following menu: "Control Unit > Inspector window > General > Catalog
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
The accessible device is displayed with IP address in the project tree.
information".
5.4 Establishing an online connection to the drive
Commissioning
155