User Interface - Trace Function - Siemens SINAMICS S120 Commissioning Manual

3.5

User interface - trace function

Structure of the user interface
The user interface of the trace function is made up of several display areas. The following figure
shows an example of the structure of the trace user interface.
①
Project tree: Here, you can add a new trace or call an existing trace.
②
Status display: The status of the actual trace recording is displayed here. The status is displayed in the online mode
only.
③
Toolbar: You manage traces in the project and in the drive using the operator controls in the toolbar.
④
Configuration: Here, you perform the device-specific configuration of the trace (e.g. duration of recording, trigger
condition, signal selection).
⑤
Diagram: The recorded values are displayed in a curve diagram here. The signal sources of the displayed
measurement are also displayed.
⑥
Trace: The measurement cursor data and snapshots are displayed here.
⑦
Inspector window: General information on the trace configuration is displayed here.
Figure 3-11 Example: CU320-2 PN
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Startdrive engineering tool
3.5 User interface - trace function
55