Control Interface Module In The Basic Line Module Chassis Format - Siemens SINAMICS S120 Commissioning Manual

Table 6-16 Meaning of the LED "POWER OK" on the Control Interface Module in the Active Line Module
LED Color
POWER OK Green
6.1.2.10

Control Interface Module in the Basic Line Module chassis format

Table 6-17 Meaning of the LEDs "Ready" and "DC Link" on the Control Interface Module in the Basic Line Module
LED, state
Ready DC link
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Green / red ---
flashing light
0.5 Hz
Green / red ---
flashing light
2 Hz
Green / ---
orange
or
red / orange
flashing light
2 Hz
Table 6-18 Meaning of the LED "POWER OK" on the Control Interface Module in the Basic Line Module
LED Color
POWER OK Green
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
State Description
Off DC link voltage < 100 V and voltage at -X9:1/2 less than 12 V.
On The component is ready for operation.
Flashing light There is a fault. If the LED continues to flash after you have performed a POWER
ON, please contact your Siemens service center.
Description
The electronic power supply is missing or lies outside the permissible tolerance range.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is activated irrespective of any reconfiguring of the corresponding messages.
Firmware is being downloaded.
Firmware download is complete. Wait for POWER ON.
Component detection using LED is activated (p0124).
Note:
Both options depend on the LED state when module recognition is activated via p0124 = 1.
State Description
Off DC link voltage < 100 V and voltage at -X9:1/2 less than 12 V.
On The component is ready for operation.
Flashing light There is a fault. If the LED continues to flash after you have performed a POWER
ON, please contact your Siemens service center.
Diagnostics
6.1 Diagnostics using LEDs
295