Transferring The Trace Configuration To The Device - Siemens SINAMICS S120 Commissioning Manual

4. Should you wish to set the maximum recording time, activate the option "Use max. recording
duration".
5. Enter a recording cycle under "Cycle" The possible cycle settings depend on the number of
signals.
Trigger condition: Trigger on fault
1. Select a trigger parameter from the "Trigger variable" field (see "Trigger on variable").
2. In order to record a time period before the trigger event, enter a value greater than 0 in the
input field for the pre-trigger.
3. Enter the recording time under "Recording duration". The maximum possible recording
duration is displayed to the right.
4. Should you wish to set the maximum recording time, activate the option "Use max. recording
duration".
5. Enter a recording cycle under "Cycle" The possible cycle settings depend on the number of
signals.
Further information
Further information on handling the trace function and the configuration and evaluation of the
trace is provided in the information system of the Startdrive.
6.2.2.3

Transferring the trace configuration to the device

Overview
The following describes how you can transfer a trace configuration into the drive.
Requirements
• A valid trace configuration is provided in the "Traces" system folder.
• The maximum number of traces has still not been reached.
Procedure
Proceed as follows to transfer a trace configuration to the drive:
1. Open a valid trace configuration in the working area.
2. Click on icon
The "Go online" dialog is displayed if an online connection to the drive has not been active up
until now.
Here, make the settings for the online connection (see Chapter "Establishing an online
connection to the drive (Page 152)") and click on "Connect".
The trace configuration is transferred to the drive.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
.
Diagnostics
6.2 Diagnostics via Startdrive
323