Siemens SINAMICS S120 Commissioning Manual page 98

Commissioning
5. Commission the drive via the control panel. (Page 244)
6. Result: The motor turns.
Loading the configuration of the drive offline into the project
For commissioning a drive by uploading the drive configuration to the project, the following
steps are required:
1. Create a project with Startdrive (Page 171).
2. Establish an online connection to the drive. (Page 152)
3. Load the configuration of the drive into the project (Page 168).
4. Edit the determined device configuration in Startdrive. (Page 179)
5. Perform the basic parameterization of the drive units. (Page 180)
6. Download the project to the target device (Page 242).
7. Commission the drive via the control panel. (Page 244)
8. Result: The motor turns.
Creating a project by reading out a device configuration
The following steps are necessary for commissioning a drive by reading out a device
configuration:
1. Create a project with Startdrive (Page 171).
2. Optional: Establish an online connection to the drive. (Page 152)
3. Determining the drive configuration. (Page 174)
4. Edit the determined device configuration in Startdrive. (Page 179)
5. Perform the basic parameterization of the drive units. (Page 180)
6. Download the project to the target device (Page 242).
7. Commission the drive via the control panel. (Page 244)
8. Result: The motor turns.
96
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2