Creating Or Calling A Trace - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
6.2 Diagnostics via Startdrive
Note
Saving a trace configuration and recording
You save the trace configuration and record together with the project in Startdrive.
If you close the project without saving it, then the trace configurations and the measurements
transferred into the project are rejected. Until the project is closed, the trace can be closed and
re-opened without any data being lost.
Further information
The most important functions and settings for the trace function are explained in the following
chapters. Furthermore, you receive further information about the trace in the information
system of the Startdrive.
User interface elements
You can find an overview of the most important user interface elements of the trace function
here: "User interface - trace function (Page 55)".
6.2.2.1

Creating or calling a trace

Overview
Traces in the form of trace configurations can be created in the project tree. Trace
configurations that have been saved can be called and modified.
Below it is described how you create a trace configuration under the system folder
and how you display a trace configuration that has been saved.
Requirements
• A drive has been configured that supports the trace function.
Creating a new trace
To create a new trace, double-click on the entry "Add new trace".
A new trace configuration is created.
318
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
"Traces" -