Loading Project Data From The Converter - Siemens SINAMICS S120 Commissioning Manual

4.8

Loading project data from the converter

Overview
You can load the saved project data from your drive unit into your current project in Startdrive.
Requirements
• A project is open.
• The hardware configuration and software to be loaded must be compatible with the
Startdrive (see Chapter "Checking the firmware version (Page 154)"). If the data on the device
was created with a previous program version or with a different configuration software,
please make sure they are compatible.
Procedure
To load the project data from a drive unit into your Startdrive project, proceed as follows:
1. Call the shortcut menu "Load from device (software)" or click on the icon
device) in the toolbar.
The "Upload preview" dialog box opens. Startdrive checks whether all requirements for
loading have been met. In the event of any obstructions, these are displayed as messages in
the dialog.
2. Check the alarms in the "Upload preview" dialog, and select the necessary actions in the
"Action" column.
As soon as uploading becomes possible, the "Upload from device" button is enabled.
3. Click the "Upload from device" button.
The loading operation is performed.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
4.8 Loading project data from the converter
Fundamentals
(Load from
87