Making Detailed Settings - Siemens SINAMICS S120 Commissioning Manual

Commissioning
5.3 Creating a project offline
Assignment of measuring system to Sensor Modules
The following table gives an overview of the assignment of the various measuring systems to the
available Sensor Modules.
Measuring systems
Resolver
Incremental encoder sin/
cos (1Vpp) with zero pulse
Incremental encoder sin/
cos (1Vpp) without zero
pulse
EnDat absolute encoder
Incremental Encoder
TTL/HTL
SSI absolute encoder
2)
Temperature evaluation
1) Only for direct measuring systems.
Only starting at article number 6SL3055-0AA00-5CA1.
2)
Protective separation.
3)
Note
Sensor Modules of the type Sensor Modules Cabinet (SMC) are intended for internal cabinet
installation.
Further information
You can find additional information about the Sensor Modules in the "Control Units and
Additional System Components" Manual and in the Startdrive information system.
5.3.8.4

Making detailed settings

Overview
You can configure the following encoder details for measuring systems during commissioning:
• Actual value processing
• Encoder details (e.g. encoder type, incremental tracks, gear ratio).
Procedure
To configure the encoder details, proceed as follows:
1. Select the encoder in the device view and open the inspector window.
2. In the inspector window, select the "Measuring system details" menu.
144
SMC
SMC10 SMC20 SMC30
x -
- x
- x
- x
- -
- -
x x
SMC40 1) SME20
- - -
- - x
- - x
- x -
x - -
x - -
x - -
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
SME
SME25 SME120 SME125
-
- x
x x
x
-
-
- x 3)
Commissioning with Startdrive
x
x
x 3)