Installing A Pci Card; Figure 14 Pci Slot Numbering - Sun Microsystems Sun Enterprise 10000 Instructions Manual

6. Tighten discrete attachment hardware to a torque setting of 0.7–0.8 Nm (6.1–6.9
inch-pounds).

Installing a PCI Card

1. Determine the slot for installing the PCI card. See
Caution – The PCI I/O module is limited to the slower speed of the installed PCI
!
cards. Therefore, when installing two I/O cards onto an I/O module, install like-
speed PCI cards.
FIGURE 14
2. If a filler panel covers the PCI slot, remove the PCI retention screw on the mating
flange to remove the filler panel (
Retain the screws to attach the PCI card.
3. Attach a wrist strap and take the PCI card out of the protective packaging. Inspect
the connector to make sure that it is not damaged.
4. Confirm that the installed riser card is the correct voltage for the PCI card to be
installed.
PCI Slot Numbering
Installing PCI Components on the Sun Enterprise 10000 System
FIGURE 14
PCI 0
PCI 1
).
FIGURE 9
.
13