Setting Or Viewing Scsi Ids; Setting Scsi Ids - Sun Microsystems StorEdge L280 Manual

4.4

Setting or Viewing SCSI IDs

Press the Next button to enter the following:
ADMIN * / PSWD ### ### ### / SCSI IDs *
Note – Before setting SCSI IDs, check to see which IDs are available.
When you choose
SET IDs * assigns a SCSI ID to the drive and a SCSI ID to the autoloader
controller.
VIEW IDs * displays the drive and autoloader controller settings.
TABLE 4-1
TABLE 4-1
Device
Autoloader ID
Drive ID
4.4.1

Setting SCSI IDs

To set SCSI IDs, press the Next button to enter the following:
ADMIN * / PSWD ### ### ### / SCSI IDs */ SET IDs *
1. When
AUTOLOADER ID #
AUTOLOADER ID #
DRIVE ID #
settings.
2. Press
current SCSI address flashes.
4-4 StorEdge L280 Service Manual • February 1998
, you have two options:
SCSI IDs
shows the default settings.
Default SCSI IDs
SCSI ID
1
0
is displayed, press
SET IDs *
,
DRIVE ID #
stands for the current SCSI ID of the autoloader controller.
is the current SCSI ID of the drive.
Next until the setting to change is displayed, and then press
.
Enter
, or is displayed.
UPDATE IDS NOW
UPDATE IDS NOW
is used to save ID
Enter . The