View/Change Configuration Settings; Explanation Of The Trees - Sun Microsystems StorageTek T10000 Operator's Manual

The Change TCP Configuration submenus allow you to enable/disable Dynamic Host
Control Protocol (DHCP), set a static IP address, set a static Network Mask (NM),
and/or set a static net Gateway. See
The Drive Operations submenus allow you to perform various drive utilities. See
TABLE 4-4 on page 76
The view-only Drive Firmware Level Menu displays the current drive firmware release
level, same as the Online Main Menu Operation.
The Exit Menu allows you the choice to loop-back to the Online/Offline selection menu
by pressing Menu (No), or to exit the menu system by pressing Select (Yes).
Note – If you exit the menu system with the drive offline, the Operator Panel
alternately flashes Offline (if a data cartridge has been loaded at least once) as a
reminder that drive status is still offline. This reminder flashes until the drive placed
back online, or powered-off.

View/Change Configuration Settings

You can view (only) current configuration settings when the drive is online; or, you can
view or change configuration settings when the drive is offline. Use the menu trees for
quick reference road maps, or the drive configuration table (
more detailed instructions.

Explanation of the Trees

Press Menu to advance the menu display, to set a menu option after selection, or to
answer No to a menu choice question. Press Select to toggle/increment menu
options, or to answer Yes to a menu choice question. When there is not an option,
selection, or choice presented, such as during view-only menus, pressing Select has
same result as pressing Menu.
To enter variable characters or digits, press Select to start the change mode. (The left-
most segment begins to flash.) Each additional press of the Select switch increments
the value one step. When the desired value appears, press Menu to set the value and
advance flash to the next variable character/digit. When the last variable
character/digit has been set, press Menu to accept the displayed entry and advance to
the next menu, or press Select to restart the change mode.
96174 • Revision EA
TABLE 4-3 on page 71
for additional information.
View/Change Configuration Settings
for additional information.
) for
TABLE 4-1 on page 60
Chapter 4 Menu System 57