Polaris Virage TX 2000 Service Manual page 37

MAINTENANCE/TUNE UP
Cable Adjustments
Choke Cable Inspection
Cable Inspection
1. Choke operation should be smooth when opening and
closing.
2. Inspect cable for proper routing, kinks, or damage and
replace if necessary.
Choke Cable Adjustment - SLX / Pro 1200
Choke Lever
1. Adjust choke cable by loosening lock nuts at carburetor
and moving cable up or down in holder until lever has
specified free play. Remove air intake cover and
observe choke plate position. The choke plate(s) in
carburetor(s) must close completely when choke is fully
on, and be completely vertical when the knob or lever is
returned to the off position.
2. Tighten nuts securely and re-check lever free play. Turn
bars from full left to full right through entire range of
motion and verify that at least the minimum lever play is
present in all handlebar positions. Be sure cable is
routed properly through the handlebar pad and down
the steering post.
Choke Cable Adjustment - Virage TX / Genesis / FFI
1. Adjust choke cable by loosening lock nut on cable.
Turning the adjuster in (clockwise) increases choke
lever freeplay. Turning the adjuster out
(counterclockwise) decreases choke lever freeplay.
2. Tighten lock nut securely when adjustment is complete.
Choke Lever Free Play
1/8-1/4" (3-6mm)
Choke Off
Choke Applied
3/00
2.20
Polaris Sales Inc.