Polaris Virage TX 2000 Service Manual page 299

DIAGNOSTIC SOFTWARE
Setting Up The EMM
1. Locate the diagnostic port on the engine wiring
harness. It is positioned to the aft of the EMM on
the starboard side of the boat. The port has a cov
er to keep connections clean. Remove the cover
to access the port. Connect the communication
cable (PN 2872454) to the diagnostic port on the
watercraft.
NOTE: When you are finished with all testing,
make sure you protect the diagnostic port by rein
stalling cover.
Connect the other end of the diagnostic cable to
the serial port on the laptop computer.
2. Disconnect the 8-pin connector to the EMM and
install the FFI ™ EMM Service Power Connector
PN 2872456. This will power up the EMM.
3. If removed, reinstall the lanyard.
These are connected
during engine opera
tion
Diagnostic Port
Diagnostic Cable
Cap
Front of Boat
EMM Service Power
Connector PN 2872456
Diagnostic Software Overview
The FFI ™ Diagnostic software program can either be run from your computer's "A" drive, or "C" drive. Instal
ling the software on your computer's "C" drive will allow the program to run much faster, as well as retain pre
vious consumer FFI ™ information on your hard drive.
For 2000, the FFI ™ diagnostic software disk has been upgraded with a special boot program. This program
was developed to overcome problems with the software not communicating with the EMM. When used, your
computer will immediately boot, load, and run the FFI ™ diagnostic software without any input from the user.
Starting the Diagnostic Session with the Boot Program
NOTE: The following procedure should only be performed if you have previously installed the FFI ™ diagnos
tic software on your computer, but the software is unable to communicate with he EMM.
1. If already on, turn your computer off.
9.2
n/nn