Polaris Virage TX 2000 Service Manual page 214

HULL/DECK, STEERING AND CONTROLS
Steering Cover/Steering Post
Steering Cover/Steering Post (Handlebar) Removal Cont.
1. Remove steering cover (handlebar pad) by loosening
the (6) screws located on underside of pad.
2. Spread bottom of cover apart and lift it up and
rearward. Note throttle cable and switch wire
/outing for reassembly.
3. If handlebar is to be replaced, remove screws on
throttle block and remove block. If post is not being
replaced disconnect cable from throttle lever. Remove
cable from throttle block by loosening jam nut and
unscrewing adjuster.
4. Remove the (3) stop switch screws, separate the
switch and set it aside.
5. Remove (4) bolts on handlebar clamp and remove
handlebar.
6. Remove steering cable from steering arm.
7. Remove (4) bolts on steering housing.
8. Slide steering column up and out of the support hub.
Reverse procedure for reassembly. Grease column.
9. Re-install cover. Route wires and cable behind
handlebar and through seal grommet in deck.
Virage TX / Genesis
Models
Remove screws (6)
SLX/Pro 1200
Remove screws (4)
WARNING
Be certain to check for free and correct operation of the
steering system when reassembly is complete.
Polaris Sales Inc.
6.17
3/00