Polaris Virage TX 2000 Service Manual page 226

ELECTRICAL
Specifications
Warning Systems Operating Characteristics
Following is a quick reference chart showing how each model warns the operator and/or protects the engine when
the engine overheats, or when a low fuel or oil condition exists.
Year
2000
2000
2000
2000
2000
Model
Virage TX
SLX
Pro 1200
Genesis
Genesis FFI ™
Temp Sensor
"ON"
@ F7C°
237±8°F/114°C
237±8°F/114°C
237±8°F/114°C
237+8° F/114° C
237±8°F/114°C
Light
(MFD)
Oil, Heat, Fuel
Oil, Heat, Fuel
Oil, Heat, Fuel
Oil, Heat, Fuel
Oil, Heat, Fuel
Some models limit RPM to 4500 in the event of an overheat or low fuel condition. Refer to the chart for the system
in use on each model.
Stator Plate Assembly And Ignition System Test Specifications
All specifications are listed on the appropriate wiring diagram. Refer to the wiring diagram for the model you
are working on. If resistance specifications are not listed on the wiring diagram, use specifications listed be
low. Refer to test procedures in this section.
All electrical resistance readings should be done at room temperature. Reading may vary ± 10%. Disconnect
component to be tested. Always subtract meter lead resistance when measuring small resistance values. Meter
readings were obtained using either a Fluke™ 73 or Tektronix™ DMM155 digital multitester. Use of other meters
may produce different results.
NOTE: Most meters will not be able to measure a resistance this low. Touch the meter leads together, view your
meter, and record this reading. Measure the alternator coil wire connections, or the primary coil connections listed
above. The reading should be the same as what you recorded when the meter leads were shorted together.
■r
Polaris Sales Inc.
7.3
3/00