Polaris Virage TX 2000 Service Manual page 216

HULL/DECK, STEERING AND CONTROLS
Cable Adjustments
Steering Cable Adjustment
1. Open front door compartment on watercraft. Open
tool kit panel in order to access steering assembly.
2. Locate hole at the base of the steering shaft mount.
Align handlebars so that the hole in the steering
shaft aligns with the hole in the mount. Insert a 1/8"
dowel or drill bit into locking hole. The handlebars
are now locked in the center position.
Insert drill bit or dowel into hole to lock
steering in center position.
3.
4.
Place a straight edge across horizontal center line
of steering nozzle or trim nozzle. NOTE: The trim
nozzle mounting bolts can be used as a reference
for the center line on models with Quick Trim.
See III. 2.
Measure distance from straight edge to hull on left
and right side. Be sure to measure at right angles to
the straight edge and at equal distances from the
nozzle. The distance at "X" should be equal when
handlebars are straight. See III. 3.
Rear View Of Pump Nozzle
Place straight edge across horizontal
center line of steering nozzle or trim
nozzle.
Straight Edge
Hull
Nozzle
Hull
Distance should be equal at "X"
Polaris Sales Inc.
6.19
3/00