Polaris Virage TX 2000 Service Manual page 261

ELECTRICAL
Multi-Function Display
Multi-Function Display
The Polaris Multi-Function Display (MFD) allows the operator to see such important information as time run, dis
tance run, maximum speed, current speed, fuel level and more at the touch of a button. Following is a summary
of operating instructions for both styles of MFDs. A description of Operating Modes and Key Function is listed
below followed by Troubleshooting the MFD system.
Multi-Function Display
OPERATION AND MODES
NOTE: Not all MFDs have all these functions.
HOUR: Secondary display function controls multi-LCD when selected by mode key. HOUR annunciator is on
when in HOUR mode. Actual engine run hours are displayed in. 1 hour increments from 0 to 999.9 hours. HOURS
can be neither reset nor lost when power is removed due to nonvolatile EEPROM memory.
CLOCK: CLOCK is a secondary display function and controls multi-LCD when selected by mode key. CLOCK
annunciator is on when in CLOCK mode. To set the time, first enter CLOCK mode and then hold the SET key
for 2-4 seconds to enter CLOCK SET mode. Both keys are now used to adjust the time. MODE selects the digit,
SET advances the digit. Press MODE when complete to start the clock (colon begins to flash).
PEAK SPEED/RPM: While in TACH mode, pressing the SET key will display both the peak speed and maximum
sustained RPM since the last reset or auto-off occurred. While displayed, holding the SET key for 4 seconds will
reset the peak memories.
KEY FUNCTIONS AND DISPLAY
MODE KEY: Toggles multi-LCD display modes as pressed. Annunciators scroll from left to right to indicate selec
tion.
SET KEY: Function varies with selected mode. Used to temporarily disable warning indications, to access peak
speed and RPM while in TACH mode, reset distance in DIST mode, select MPH - Km/H while in VOLT mode,
and to set time while in CLOCK mode.
LCD DISPLAY: Displays variety of both essential and performance data: speed, RPM, fuel level, oil level, trim
position, distance, voltage, engine hours, clock, peak speed, peak RPM, and warning conditions (low fuel, low
oil, low power, high temperature).
WARNING LED: Super bright LED flashes to alert rider of warning condition. Actual condition is then displayed
in multi-LCD readout.
SPEED: Primary display function, controls left LCD at all times. Displays speed with .1 MPH resolution from
5-75 MPH. Input is received from jet intake fin.
TACH: Yellow wire from alternator: Default secondary display function, controls Multi-LCD at power on or
when selected by MODE key. RPM annunciator is on when in TACH mode.. Displays RPM with 10 RPM resolu
tion.
3/00 7.38
Polaris Sales Inc.