Polaris Virage TX 2000 Service Manual page 308

Service Code Screens
Illustration at right is a Service Code screen. Code
screens are displayed in the same sequence as
presented on the Service Code Review screen.
You get to them by pressing any key at the Service
Code Review screen. They display the following
information.
• Code #:
An identifying number given to each code.
• Class:
Hard, Intermittent, or Repaired
• # of Events:
Indicates how many times this code has
been stored. This field can only in
crease by one each time the engine is
run. This means that if a code occurs
several times during a run, it will only
increase this counter by one.
Last Event at Hrs.:
DIAGNOSTIC SOFTWARE
FFI Diagnostics
CODE #14
# OF EVENTS 1
# 3 OF 3 CODES
CLASS: INTERMITTENT
LAST EVENT AT 13 HRS
TOTAL ENGINE HRS 13
CODE DESCRIPTION: Throttle position sensor
above expected range.
CODE ANALYSIS: The EMM is detecting a Throttle Position
Sensor value that is higher than expected. This can be
caused by mechanical damage to the sensor or linkage
that increases the sensor travel toward the WOT posi
tion. Damage to the sensor could also cause this Ser
vice Code. See Diagnostic Manual.
PRESS ANY KEY FOR NEXT CODE
Indicates the number of operating hours
on the engine when this code was last
present. This field will update during a
run (during a single power-up cycle).
For instance, if a code occurs at 50
hours, and is still occurring at 51, 52,
and 53 hours, the counter will advance
to 53 hours. This, however, is not a live
data screen. The counter is read only
when you begin a diagnostic session.
NOTE: You must exit the diagnostic
session, return to the Main Menu, then begin a
new diagnostic session to see the counter change
value.
of. Codes:
How many codes are present, and
which code you are presently viewing.
Total Engine Hours:
Current number of operating hours on
the engine, compare this number to the
LAST EVENT AT HRS. number to
determine how long since the code was
last set.
3/00
9.11
Polaris Sales Inc.