Polaris Virage TX 2000 Service Manual page 262

ELECTRICAL
Multi-Function Display
FUEL: Pink wire from sending unit at fuel tank: Primary display function controls left hand bar graph at all
times. Displays in 1/8 tank increments. Toggles low "FUEL" display and warning LED when fuel reaches 1/8 level.
"FUEL" will flash in display regardless of Multi-LCD display mode.
OIL: Blue wire from sending unit at oil tank: Primary display function controls right hand bar graph at all times.
Displays in 1/4 tank increments. Toggles low "OIL" display and warning LED when oil reaches 1/4 level. "OIL" will
flash in display regardless of Multi-LCD display mode.
TRIM: Primary display function controls top bar graph at all times. Trim position is shown from -5 to +5 in .5
increments. Because of the safety clutch in the trim motor, it may be necessary to re-synchronize the TRIM dis
play if the nozzle should be deflected upward. This is accomplished by simply running the trim motor until both
the trim nozzle and display are at their limits (either up or down).
DIST (Distance) Internal function: Secondary display function controls Multi-LCD when selected by mode key.
DIST annunciator is on when in DIST mode. Distance is displayed in .1 mile increments from 0 to 999.9. Distance
can be reset by pressing the SET key for 4 seconds while in DIST mode.
VOLT: Red wire, purple tracer: Secondary display function controls Multi-LCD when selected by mode key.
VOLT annunciator is on when in VOLT mode. Voltage is displayed in .1 volt increments from 5 to 18 volts.
ENGLISH/METRIC: While in the VOLT mode, pressing and holding SET will toggle the instrument between MPH
and KPH. The distance function is automatically toggled at the same time.
LOW POWER: If battery voltage drops below 10.9 volts, the Multi-LCD display will flash "LOPR". If this occurs,
the speed and distance functions will cease until power is restored.
HIGH TEMP: When a hot engine signal is received, the Multi-LCD display will flash "HOT" and the warning LED
will light.
WARNING RESET: When warning conditions occur, pressing the SET key will deactivate the warning depending
on the condition: HOT: Only LED is disabled for 5 minutes: FUEL: Both LED and LCD are disabled for 5 minutes;
OIL: Both LED and LCD are disabled for 15 minutes.
ON/AUTO ON: When system is off, a single press of MODE key will turn the MFD on. When the engine is started,
the MFD will automatically power on.
AUTO OFF: After 5 minutes of no activity, the system automatically shuts itself off. The internal clock continues
to keep time. Memory functions (distance, hours, MPH/KPH) are retained, and the clock, fuel level, and oil level
will be displayed.
Polaris Sales Inc. 7.39 3/00