Moving Rear (Right) Wheels Into Field Position - MacDon D65 Operator's Manual

9. Lift the wheel assembly to the desired height and slide
linkage (A) into the appropriate slot in the vertical support.
10. Push handle (B) down to lock it.

Moving Rear (Right) Wheels into Field Position

The rear wheels are located farthest from the towing vehicle. To prepare for operation in the field, the rear wheel
assembly must be rotated to face the cutterbar and lifted to the desired height.
1. Pull pin (A) on the left rear wheel. Swivel the wheel
clockwise and lock with the pin.
2. Remove pin (A) and store at location (B).
3. Pull handle (C) upward to release.
4. Lift the wheel to the desired height, and engage the
support channel into slot (D) in the vertical support.
5. Push handle (C) down to lock.
214327
OPERATION
Figure 3.92: Front Wheels – Left
Figure 3.93: Rear Wheel – Right Side
Figure 3.94: Rear Wheel – Right Side
102
A
B
A
B
D
C
A
Revision B