MacDon D65 Operator's Manual page 238

6. Tighten clamp (A) using modified channel lock pliers (B)
until finger pressure will NOT move the clamp.
IMPORTANT:
Overtightening the clamp might break the clamp.
7. Line up tine tube (B) with the cam arm and install bolt (A).
Apply medium-strength threadlocker (Loctite
equivalent) to the bolt, and torque the bolt to 165 Nm
(120 lbf·ft).
NOTE:
Make sure the shim is between the cam arm and the reel
bat.
8. Install bolts (A) securing arm (B) to the center disc.
9. Install reel arm (B) and endshield support (C) to the tail end
of the reel at the applicable tine tube location, and secure
them with bolts (A).
214327
MAINTENANCE AND SERVICING
Figure 5.188: Clamp on Bushing
® 243 or
Figure 5.189: Cam End
Figure 5.190: Tail End
218
A
B
A
B
A
B
C
Revision B