MacDon D65 Operator's Manual page 237

NOTE:
Use a pair of modified channel lock pliers (A) to install bushing
clamps (C). Secure the pliers in a vise and grind a notch (B) into
the end of each arm to fit the clamp as shown.
Installing cam end bushings:
1. Position bushing halves (B) on the tine tube with the
flangeless end adjacent to the reel arm, and position the
lug in each bushing half into the hole in tine tube (A).
2. Slide tine tube (A) toward the tail end of the reel to insert
bushing (B) into the reel arm.
NOTE:
If the tine tube supports are installed, ensure the bushings
at those locations slide into the support.
3. Reinstall the previously removed fingers or tines. Refer to
the following procedures as necessary:
•
Removing Plastic Fingers, page 209
•
Removing Steel Tines, page 208
4. Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
5. Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
214327
MAINTENANCE AND SERVICING
Figure 5.185: Modified Pliers
Figure 5.186: Cam End
Figure 5.187: Bushing
217
B
A
A
A
B
C
B
Revision B