Installing Endshield - MacDon D65 Operator's Manual

Installing Endshield

1. Position the endshield onto support (A), and align the hole
in the endshield with stud (B) on the support.
2. Secure the endshield to the support with acorn nut (A).
3. Close the endshield. Refer to
NOTE:
Polyethylene endshields may expand or contract when
subjected to large temperature changes. Top pin and lower
catch bracket positions can be adjusted to compensate for
dimensional changes. Refer to
214327
OPERATION
Closing Endshield, page 36.
Adjusting Endshield, page
A
Figure 3.14: Left Endshield
39.
Figure 3.15: Left Endshield
38
B
A
Revision B