MacDon D65 Operator's Manual page 242

22. For the opposite tine tube, rotate support (A) or slightly
move the tine tube until it clears channels (C).
23. Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
24. Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
25. Tighten clamp (A) using modified channel lock pliers (B)
until finger pressure will NOT move the clamp.
IMPORTANT:
Overtightening the clamp might break the clamp.
214327
MAINTENANCE AND SERVICING
Figure 5.198: Opposite Support
Figure 5.199: Bushing
Figure 5.200: Clamp on Bushing
222
A
C
A
B
A
B
Revision B