MacDon D65 Operator's Manual page 85

Reposition right arm cylinder as follows:
NOTE:
Reel components not shown in illustration for clarity.
6. Remove four bolts (A) securing cylinder bracket (B) to the
reel arm.
7. Position reel until bracket (B) lines up with desired position
holes (C):
• Forward position, refer to Figure
• Rearward position, refer to Figure
8. Reinstall the four bolts (A) to secure bracket to reel arm at
new position.
Reposition the left reel arm cylinder as follows:
NOTE:
Reel components not shown in illustration for clarity.
9. Remove pin (A) securing cylinder (B) to bracket/light
assembly (C).
10. Remove bolts (D) securing bracket/light assembly (C) to the
reel arm, and remove the bracket/light assembly.
11. If necessary, remove the cable tie securing the harness to
the bracket/light assembly (C) or reel arm.
12. Swivel the light to the working position as shown.
214327
OPERATION
3.40, page 65
3.41, page 65
65
Figure 3.40: Forward Position
Figure 3.41: Rearward Position
C
A
Figure 3.42: Left Reel Arm Cylinder in Forward
Position
B
C
A
B
C
A
B
D
D
Revision B