Installing Bushings On Five-, Six-, Or Nine-Bat Reels - MacDon D65 Operator's Manual

23. Slide support (A) off bushing halves (B).
NOTE:
Two tine tubes have opposite-facing supports. Rotate the
supports until the flanges clear the channels before moving
them off bushing (B). Move the tine tube outward slightly if
necessary.
24. Remove bushing halves (B).

Installing Bushings on Five-, Six-, or Nine-Bat Reels

Once the old tine tube bushing halves have been removed, the new ones can be installed.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
214327
MAINTENANCE AND SERVICING
Figure 5.183: Support
Figure 5.184: Opposite Support
216
B
B
A
Revision B