MacDon D65 Operator's Manual page 10

Section
Removing Steel Tines, page 208
Removing Bushings from Five-,
Six-, or Nine-Bat Reels, page 211
7.4 Header and Drapers, page
263
—
6.4.3 Draper Clips, page 251
8.3 Unloading and Assembly,
page 280
214327
Summary of Change
Replaced the following DANGER with the following DANGER:
• Old DANGER: To prevent bodily injury or death from the
unexpected start-up or fall of a raised machine, always stop the
engine, remove the key, and engage the safety props before
going under the header for any reason.
• New DANGER: To prevent bodily injury or death from the
unexpected start-up of the machine, always stop the engine
and remove the key from the ignition before making
adjustments to the machine.
Moved Step 4, page 208 to after the engine is shut off.
Replaced the following DANGER with the following DANGER:
• Old DANGER: To prevent bodily injury or death from the
unexpected start-up or fall of a raised machine, always stop the
engine, remove the key, and engage the safety props before
going under the header for any reason.
• New DANGER: To prevent bodily injury or death from the
unexpected start-up of the machine, always stop the engine
and remove the key from the ignition before making
adjustments to the machine.
Moved Step 4, page 211 to after the engine is shut off.
Added NOTE to troubleshooting information for upper cross auger
beater bars because the new UCA kits do not have beater bars
• Some newer upper cross augers do not have beater bars.
Removed "Vertical Knife Mounts" topic because the vertical knife is
not recommended for use with windrowers.
Added topic.
Corrected part numbers of the unloading and assembly manuals.
vi
Internal Use
Only
Technical
Publications
Technical
Publications
ECN 61273
Product
Support
ECN 54224
ECN 58960
Technical
Publications
Revision B