MacDon D65 Operator's Manual page 87

5. Reinstall clevis pin (B) at the new position in bracket (C),
and secure end of cylinder (D) with ring (A).
To reposition the right reel arm cylinder:
6. Remove ring (A), clevis pin (B), and washers (C) from
bracket (D). Retain the ring, clevis pin, and washers.
7. Push the reel back until the end of cylinder (E) lines up with
the reel position 2 hole on bracket (D). Position washers (C)
on both sides of the cylinder end inside the bracket.
8. Reinstall clevis pin (B) at the new position. Secure it with
ring (A).
214327
OPERATION
C
Figure 3.45: Left Reel Arm in Aft Position
B
A
Figure 3.46: Forward Position – Center Arm
C
B
A
Figure 3.47: Center Reel Arm in Aft Position
67
A
B
D
D
C
E
D
Revision B