MacDon D65 Operator's Manual page 213

6. Loosen the draper by turning adjuster bolt (A)
counterclockwise.
7. Remove connectors (B), screws (A), and nuts from the
draper joint to uncouple the draper.
8. Pull the draper off the drive roller.
9. Align the set screws with hole (A) in the guard. Remove the
two set screws holding the motor onto the drive roller.
NOTE:
The set screws are 1/4 turn apart.
10. Remove four bolts (B) securing the motor to the drive roller
arm.
NOTE:
It may be necessary to remove plastic shield (C) to gain
access to the top bolt.
214327
MAINTENANCE AND SERVICING
Figure 5.132: Tensioner
Figure 5.133: Draper Joint
Figure 5.134: Drive Roller
193
A
C
B
B
A
B
A
Revision B