Closing Endshield - MacDon D65 Operator's Manual

IMPORTANT:
Do NOT force the endshield once it has reached its end of
travel or damage to the endshield structure may result. The
endshield is designed to open sufficiently to allow access to
the drive system and manual case.
NOTE:
To access the knife drive box, carefully disengage the front
of endshield from the tab at the front of the endsheet and
swing the front of the endshield away from the header.
NOTE:
If complete access to endsheet area is required, remove
endshield. For instructions, refer to
page 37.

Closing Endshield

The header endshields cover components. After accessing the components you will need to close the endshield.
1. Maintain forward pressure and swing the rear of the
endshield towards the header.
2. Lift the endshield and engage pin (A) located on the top of
the endsheet frame with the hole in endshield (B).
3. Push in the endshield to engage lower latch (A).
4. Use tool (B) to lock lower latch (A).
214327
OPERATION
Removing Endshield,
36
Figure 3.9: Left Endshield Open
B
Figure 3.10: Left Endshield
A
B
Figure 3.11: Left Endshield
A
Revision B