MacDon D65 Operator's Manual page 201

11. Loosen mounting bolts (B) on rear deck deflector (A) (this
may help with draper installation).
12. Attach the ends of the draper with tube connectors (B),
screws (A) (with the heads facing the center opening),
and nuts.
13. Adjust the draper tension. For instructions, refer to
Adjusting Draper Tension, page
14. Check the draper seal between the drapers and the
cutterbar. Ensure there is a 1–2 mm (0.04–0.08 in.) gap (A)
between cutterbar (C) and draper (B).
15. Refer to 5.7.5 Adjusting Deck Height, page 186
the proper gap.
214327
MAINTENANCE AND SERVICING
5.7.3
182.
to achieve
181
Figure 5.108: Draper Seal
A
Figure 5.109: Draper Joint
A
C
Figure 5.110: Draper Seal
A
B
B
B
Revision B