MacDon D65 Operator's Manual page 137

Disconnecting header drive hydraulics:
7. Disengage and rotate lever (A) counterclockwise to the fully
up position.
8. Disconnect the electrical connector from the header.
9. To disconnect the hoses from the header, line up slot (A) in
collar with pin (B) on the connector.
10. Push the collar toward the pin and pull the connector to
disengage.
11. Install caps on the connectors and the hose ends (if
equipped).
Storing hose bundle on windrower support:
12. Route hose bundle (A) back onto the hose support on the
windrower.
13. Rotate lever (B) and lock in the down position.
14. Install cap (C) on the electrical connector.
15. Detach the header from the windrower. For instructions,
refer to the windrower operator's manual.
214327
HEADER ATTACHMENT/DETACHMENT
Figure 4.10: Header Drive Hydraulics
Figure 4.11: Quick Disconnect
Figure 4.12: Hose Storage
117
A
A
B
A
B
C
Revision B