MacDon D65 Operator's Manual page 83

4. Push/pull the reel until bracket (B) lines up with the fore/
aft set of holes (C).
5. Reinstall the four bolts (A) securing the cylinder bracket (B)
to the reel arm at the new position.
To reposition the left reel arm cylinder:
6. Remove pin (A) securing cylinder (B) to bracket/light
assembly (C).
7. Remove bolts (D) securing bracket/light assembly (C) to the
reel arm, and remove the bracket/light assembly.
8. Remove the cable tie securing the harness to the bracket/
light assembly (C) or reel arm if necessary.
9. Swivel the light to the working position as shown.
10. Reposition the bracket/light assembly (C) on the reel arm as
shown, and secure with four bolts (D). Tighten bolts.
11. Push the reel back and attach cylinder (B) to the bracket/
light assembly (C) with pin (A). Secure pin with cotter pin.
12. Secure the light harness to the bracket/light assembly (C)
using a cable tie.
13. Check the reel clearance to the backsheet, upper cross
auger (if installed), and reel braces.
14. Adjust the reel tine pitch if necessary. Refer to
Tine Pitch, page 68.
214327
OPERATION
Figure 3.35: Right Reel Arm Cylinder in Aft Position
Figure 3.36: Left Reel Arm Cylinder in Forward
Position
B
3.7.12 Reel
Figure 3.37: Left Reel Arm Cylinder in Aft Position
63
B
A
C
B
D
A
D
D C
A
D
C
Revision B