MacDon D65 Operator's Manual page 235

18. Locate support (A) that requires a new bushing.
19. Remove four bolts (B) securing channels (C) to support (A).
20. If finger (D) is too close to the support to allow access to
the bushing, remove screw (E) and remove finger (D). For
instructions, refer to Removing Plastic Fingers, page
21. Release bushing clamps (A) using a small screwdriver to
separate the serrations.
22. Move clamps (A) off the bushings.
214327
MAINTENANCE AND SERVICING
209.
B
Figure 5.180: Tine Tube Support
Figure 5.181: Bushing Clamp
Figure 5.182: Bushing Clamp
215
C
A
E
D
A
A
Revision B