Qos Egress Port Shapers - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Port Shaper Controls whether the port shaper is enabled for this switch port.
Enable
Port Shaper Controls the rate for the port shaper. The default value is
is restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted
Rate
to 1-3300 when the "Unit" is "Mbps".
Port Shaper
Controls the unit of measure for the port shaper rate as "kbps" or "Mbps".
The default value is "kbps".
Unit
Buttons Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved
values.
Cancel: Click to undo any changes made locally and return to the
previous page.
4.8.5

QoS Egress Port Shapers

This page provides an overview of QoS Egress Port Shapers for all switch ports.
This section provides an overview of QoS Egress Port Shapers for all switch ports.
Figure 4-52: QoS Egress Port Shapers display
Table 4-50: QoS EgressPort Shapers parameters
Port The logical port for the settings contained in the same row.
Click on the port number in order to configure the shapers.
Qn Shows "-" for disabled or actual queue shaper rate - e.g. "800
Mbps".
Port Shows "-" for disabled or actual port shaper rate - e.g. "800
Mbps".
By clicking on any port number in the above table, you may access another display, which will allow
configuring the QoS Egress Scheduler and Shapers for a specific port.
99
. This value
500