Link Protection; Link Protection Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.28

Link Protection

This section allows the user to configure the Link Protection Parameters and check the status
4.28.1

Link Protection Configuration

Figure 4-213: Link Protection Configuration
Table 4-186: Link Protection Configuration Parameters
Mode Enable or Disable the Link Protection function.
Main Port Select the uplink port that will serve as main (the other will be
automatically assigned as backup).
Revertive Enable or Disable revertive operation. When enabled, main connection
will be restored after a previous failure on that link has been fixed. The
Wait To Restore (WTR) timer will be triggered when main is back online.
WTR Set the Wait To Restore timer (in seconds), which will be triggered when
main link is restored after failure.
Buttons Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously
saved values
Refresh: Click to refresh the list.
Auto-refresh
the page at regular intervals.
Clear: Click to clear the list
: Check this box to enable an automatic refresh of
354