Rmon (Remote Network Monitoring); Armon Alarm Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.23

RMON (Remote Network Monitoring)

The Remote Network Monitoring (RMON) MIB was developed by the IETF to support monitoring
and protocol analysis of LANs.
M-Class series support RMON 1 (RFC2819) groups 1, 2, 3 and 9.
4.23.1

ARMON Alarm Configuration

This section provides configuration of RMON Alarm table. The entry index key is ID.
Figure 4-204: RMON Alarm Configuration
Table 4-177: RMON Alarm Configuration Parameters
Delete Check to delete the entry. It will be deleted during the next save.
ID Indicates the index of the entry. The range is from 1 to 65535.
Interval Indicates the interval in seconds for sampling and comparing the rising and
falling threshold. The range is from 1 to 2^31-1.
Variable Indicates the particular variable to be sampled, the possible variables are:
InOctets: The total number of octets received on the interface, including
framing characters.
InUcastPkts: The number of uni-cast packets delivered to a higher-layer
protocol.
InNUcastPkts: The number of broad-cast and multi-cast packets delivered to
a higher-layer protocol.
InDiscards: The number of inbound packets that are discarded even the
packets are normal.
InErrors: The number of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol.
InUnknownProtos: the number of the inbound packets that were discarded
because of the unknown or un-support protocol.
OutOctets: The number of octets transmitted out of the interface , including
framing characters.
OutUcastPkts: The number of uni-cast packets that request to transmit.
OutNUcastPkts: The number of broad-cast and multi-cast packets that
request to transmit.
OutDiscards: The number of outbound packets that are discarded event the
packets is normal.
OutErrors: The The number of outbound packets that could not be
transmitted because of errors.
OutQLen: The length of the output packet queue (in packets).
345