Qos Ingress Port Policers - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.8.2

QoS Ingress Port Policers

This section allows you to configure the
A can limit the bandwidth of received frames. It is located in front of the ingress queue.
policer
Figure 4-48: QoS Ingress Port Policers
Table 4-46: QoS Ingress Port Policers Parameters
Port
Enabled
Rate
Unit
Flow Control
Buttons
Policer
The port number for which the configuration below applies.
Controls whether the policer is enabled on this switch port.
Controls the rate for the policer. The default value is
restricted to 100-1000000 when the "Unit" is "kbps" or "fps", and it is
restricted to 1-3300 when the "Unit" is "Mbps" or "kfps
Controls the unit of measure for the policer rate as kbps, Mbps, fps or
kfps . The default value is "kbps".
If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames.
Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved
values.
settings for all switch ports.
95
. This value is
500