Loopback Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.27

Loopback Configuration

This section displays current loopback configuration. (L2 and/or L3 frame type)
Loopbacks can also be configured here.
Figure 4-212: Loopback configuration
Table 4-185: Loopback configuration Parameters
Delete
If marked and save button is pressed, the loopback is deleted
Mode
The Loopback mode; Port based or VLAN.based
State
The loopback state; Enable means active, Disable means inactive.
Direction The Loopback direction; Up means towards network, Down means towards
access.
Port The port on which the loopback operates (uplink ports).
VLAN ID The VLAN ID on which the loopback operates (in port mode all VLANs are
effective)
Priority The priority on which the loopback operates; currently all PCP codes will be
looped back.
L2 swap The frame type on which the loopback operates: if L2 is marked then all frame
with VLAN tag will be looped back, if L3 is marked then only IP packets will be
looped back.(L2 OR/AND L3)
L3 swap The frame type on which the loopback operates : if L3 is marked then only IP
packets will be looped back.(
Description
Loopback description; if loopback mode is VLAN the description is the VLAN
description, if loopback mode is port the description is the port description..
Buttons Add New Entry: Click to add a new EPS entry
Refresh: Click to refresh the page immediately.
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved
values
353