Qos Egress Port Tag Remarking - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Queue Shows the weight in percent for this queue. This parameter is only shown if
"Scheduler Mode" is set to "Weighted".
Scheduler
Percent
Port Shaper Controls whether the port shaper is enabled for this switch port.
Enable
Port Shaper Controls the rate for the port shaper. The default value is
restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted to
Rate
1-3300 when the "Unit" is "Mbps".
Port Shaper Controls the unit of measure for the port shaper rate as "kbps" or "Mbps".
The default value is "kbps".
Unit
Buttons Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
Cancel: Click to undo any changes made locally and return to the previous page.
4.8.6

QoS Egress Port Tag Remarking

This section provides an overview of
By clicking on any port, you may configure the selected port (see example for port 6)
Figure 4-54: QoS Egress Port Tag Remarking
Egress Port Tag Remarking for all switch ports.
QoS
101
. This value is
500