Detailed Link Oam Status For Selected Port - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.21.4

Detailed Link OAM Status for selected port

This page provides Link OAM configuration operational status.
The displayed fields show the active configuration status for the selected port.
Figure 4-166: Detailed Link OAM Status for selected port
Table 4-158: Detailed Link OAM Status for selected port Parameters
Local and Peer
Mode
Unidirectional
Operation
Support
Remote
Loopback
Support
Link Monitoring
Support
MIB Retrieval
Support
MTU Size
Multiplexer
State
The Mode in which the Link OAM is operating, Active or
Passive.
This feature is not available to be configured by the user.
The status of this configuration is retrieved from the PHY.
If status is enabled, DTE is capable of OAM remote loopback
mode.
If status is enabled, DTE supports interpreting Link Events..
If status ie enabled DTE supports sending Variable Response
OAMPDUs.
It represents the largest OAMPDU, in octets, supported by
the DTE. This value is compared to the remotes Maximum
PDU Size and the smaller of the two is used.
When in forwarding state, the Device is forwarding non-
OAMPDUs to the lower sublayer. Incase of discarding, the
device discards all the non-OAMPDU's.
299