Link Event Configuration For Selected Port - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Loopback Controls whether the loopback support is enabled for the
switch port.
Support
Link OAM remote loopback can be used for fault localization
and link performance testing. Enabling the loopback support
will allow the DTE to execute the remote loopback command
that helps in the fault detection
Link Monitor Controls whether the Link Monitor support is enabled for the
switch port. On enabling the Link Monitor support, the DTE
Support
supports event notification that permits the inclusion of
diagnostic information.
MIB Retrieval Controls whether the MIB Retrieval Support is enabled for the
switch port. On enabling the MIB retrieval support, the DTE
Support
supports polling of various Link OAM based MIB variables'
contents.
Loopback If the Loopback support is enabled, enabling this field will start
a loopback operation for the port.
Operation
Buttons Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to
previously saved values.
4.21.2

Link Event Configuration for selected Port

This section allows the user to inspect the current Link OAM Link Event configurations, and
change them as well.
Figure 4-164: Link Event Configuration for selected port
Table 4-156: Link Event Configuration for selected port Parameters
Port The switch port number.
Event name Name of the Link Event which is being configured.
Error Window
Represents the window period in the order of 1 sec for the
observation of various link events.
Error Represents the threshold value for the window period for the
appropriate Link event so as to notify the peer of this error.
Threshold
Error Frame
The Errored Frame Event counts the number of errored frames
detected during the specified period. The period is specified by
Event
a time interval (Window in order of 1 sec). This event is
generated if the errored frame count is equal to or greater than
the specified threshold for that period (Period Threshold).
Errored frames are frames that had transmission errors as
detected at the Media Access Control sublayer. Error Window
295