Snmpv3 User Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
5.5.4

SNMPv3 User Configuration

Configure SNMPv3 users table. The entry index keys are "Engine ID" and "User Name".
Figure 5-26: SNMPv3 User Configuration
Table 5-25: SNMPv3 User Configuration Parameters
SNMPv3 User Configuration
Delete Check to delete the entry. It will be deleted during the next save.
Engine ID An octet string identifying the engine ID that this entry should belong to.
The string must contain an even number between 10 and 64 hexadecimal
digits, but all-zeros and all-'F's are not allowed.
The SNMPv3 architecture uses the User-based Security Model (USM) for
message security and the View-based Access Control Model (VACM) for access
control.
For the USM entry, the usmUserEngineID and usmUserName are the
entry's keys. In a simple agent, usmUserEngineID is always that agent's own
snmpEngineID value.
The value can also take the value of the snmpEngineID of a remote SNMP
engine with which this user can communicate. In other words, if user engine
ID equal system engine ID then it is local user; otherwise it's remote user.
User Name A string identifying the user name that this entry should belong to.
The allowed string length is 1 to 32, and the allowed content is the ASCII
characters from 33 to 126.
Security
Indicates the security model that this entry should belong to. Possible security
models are:
Level
NoAuth, NoPriv: None authentication and none privacy.
Auth, NoPriv: Authentication and none privacy.
Auth, Priv: Authentication and privacy.
The value of security level cannot be modified if the entry already exists. This
means that must first ensure that the value is set correctly.
Authenticati Indicates the authentication protocol that this entry should belong to. Possible
authentication protocol are:
on Protocol
None: None authentication protocol.
MD5: An optional flag to indicate that this user is using MD5 authentication
protocol.
SHA: An optional flag to indicate that this user is using SHA authentication
protocol.
The value of security level cannot be modified if the entry already exists. That
means must first ensure that the value is set correctly.
396