Ptp Monitoring - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.15.3

PTP Monitoring

This section allows the user to inspect the current PTP clock settings
Two status displays are shown:
PTP External Clock Mode
PTP Clock Configuration
4.15.3.1 PTP External Clock Mode
Figure 4-125: PTP External Clock Mode
Table 4-120: PTP External Clock mode parameters
PTP External Clock Mode
One_pps_mode
External Enable
Adjust Method
Clock
Frequency
Buttons
Shows the current configured One_pps_mode.
1. Output: Enable the 1 pps clock output
2. Input: Enable the 1 pps clock input
3. Disable : Disable the 1 pps clock in/out-put
Shows the current External clock output configuration.
1. True: Enable the external clock output
2. False : Disable the external clock output
Shows the current Frequency adjustment configuration
1. LTC frequency : Local Time Counter (LTC) frequency
control
2. SyncE-DPLL : SyncE DPLL frequency control, if allowed by
SyncE
3. Oscillator : Oscillator independent of SyncE for frequency
control, if supported by the HW
4. LTC phase : Local Time Counter (LTC) phase control
(assumes that the frequency is locked by means of SyncE)
Shows the current clock frequency used by the External Clock.
The possible range of values are 1 - 25000000 (1 - 25MHz)
Auto-refresh Check this box to refresh the page
automatically. Automatic refresh occurs every 3 seconds.
Refresh: Click to refresh the page immediately
223