Voice Vlan - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.7.6

Voice VLAN

The Voice VLAN feature enables voice traffic forwarding on the Voice VLAN, then the switch can
classify and schedule network traffic. It is recommended that there be two VLANs on a port - one
for voice, one for data. Before connecting the IP device to the switch, the IP phone should
configure the voice VLAN ID correctly. It should be configured through its own GUI.
4.7.6.1 Voice VLAN Configuration
Figure 4-38: Voice VLAN Configuration display
Table 4-36: Voice VLAN Configuration parameters
Voice VLAN Configuration
Mode
VLAN ID
Aging Time
Traffic Class
Indicates the Voice VLAN mode operation.
We must disable MSTP feature before we enable Voice VLAN
It can avoid the conflict of ingress filtering
Possible modes are:
Enabled: Enable Voice VLAN mode operation
Disabled: Disable Voice VLAN mode operation.
Indicates the Voice VLAN ID.
It should be a unique VLAN ID in the system and cannot equal each port
PVID
It is a conflict in configuration if the value equals management VID, MVR
VID, PVID etc.
The allowed range is 1 to 4095.
Indicates the Voice VLAN secure learning aging time.
The allowed range is 10 to 10000000 seconds.
It is used when security mode or auto detect mode is enabled.
In other cases, it will be based on hardware aging time.
The actual aging time will be situated between the [age_time; 2 *
age_time] interval
Indicates the Voice VLAN traffic class. All traffic on the Voice VLAN will apply this
class.
82